DOM Level 3 Support


	Disclaimer

The Xerces-C++ 2.6.0 contains a partial implementation of the W3C Document Object Model Level 3. This implementation is experimental. The DOM Level 3 specification is still in working draft stage: you should not consider this implementation complete or correct.

The limitations of this implementation are detailed below. Please, read this document before using Xerces-C++ 2.6.0.


	Introduction

The Xerces-C++ 2.6.0 contains an experimental implementation of a subset of the W3C DOM Level 3 as specified in

DOM Level 3.0 Core Specification, Version 1.0 W3C Working Draft 26 February 2003 and
Document Object Model (DOM) Level 3 Load and Save Specification, Version 1.0 W3C Working Draft 26 February 2003


	Implementation of DOM Level 3 Core

The following are implemented in Xerces-C++ 2.6.0.

DOMImplementationRegistry, DOMImplementationSource
DOMException: VALIDATION_ERR
DOMDocument: set/getActualEncoding, set/getEncoding, set/getVersion, set/getStandalone, set/getDocumentURI, set/getStrictErrorChecking, renameNode, normalizeDocument
DOMEntity: set/getActualEncoding, set/getEncoding, set/getVersion
DOMErrorHandler, DOMError, DOMLocator
DOMNode: set/getUserData, isSameNode, isEqualNode, compareTreePosition, lookupNamespaceURI, lookupNamespacePrefix, isDefaultNamespace, baseURI
DOMText: getIsWhitespaceInElementContent
DOMAttr: isID, getTypeInfo
DOMElement: setIdAttributeNode, setIdAttributeNS, setIdAttribute, getTypeInfo
DOMUserDataHandler
DOMConfiguration


	Implementation of DOM Level 3 Load and Save

The following are implemented in Xerces-C++ 2.6.0.

DOMImplementationLS
DOMBuilder: does not provide implementation of parseWithContext() and DOMBuilderFilter.
DOMEntityResolver
DOMInputSource
DOMWriter and DOMWriterFilter


	Implementation of DOM Level 3 Abstract Schemas

The entire section has not been implemented in Xerces-C++ 2.6.0.